[RESOLVED] For the mainboard you guys have, have you ever considered going to a 256 microstepping board?
On microstepping, we are currently using 16th microstepping and motors with 200 steps per revolution which in combination with our drive sprockets gives us .02mm X and Y resolution. My research has shown that with higher fractional microstepping come...
[RESOLVED] Why build in your Stepper Drivers to the board? Doesn't it make it more difficult to replace them?
On built in vs modular socket, we have determined that with correct installation and heat management the built in option offers superior life to little modular driver boards. This is due to the sometimes overlooked fact that most motor driver chips a...
On e3d hot ends, we don't foresee including those as a standard option since they are already widely available from many sources. We do however encourage modifying the printer to the extent you see fit as part of our mantra "Open Source, Open Frame, ...
Please log in to post questions.