Questions

Questions (9)

Votes
Answers
Views
Question
0
votes
1
answer
23
views
updated 10 months ago
Category: Technical Details
On microstepping, we are currently using 16th microstepping and motors with 200 steps per revolution which in combination with our drive sprockets gives us .02mm X and Y resolution. My research has shown that with higher fractional microstepping come...
0
votes
2
answers
27
views
updated 10 months ago
Category: Technical Details
On built in vs modular socket, we have determined that with correct installation and heat management the built in option offers superior life to little modular driver boards. This is due to the sometimes overlooked fact that most motor driver chips a...
0
votes
1
answer
15
views
updated 10 months ago
Category: Technical Details
On e3d hot ends, we don't foresee including those as a standard option since they are already widely available from many sources. We do however encourage modifying the printer to the extent you see fit as part of our mantra "Open Source, Open Frame, ...
0
votes
1
answer
23
views
updated 11 months ago
Category: Troubleshooting
When I am trying to update my firmware I get an error that says no port selected. What gives?
0
votes
1
answer
23
views
updated 11 months ago
Category: Troubleshooting
Where can I download the firmware from for my RB3 or RBB3 printer?
0
votes
1
answer
30
views
updated 11 months ago
Category: Troubleshooting
My printer seems to stop printing every second or so and then continue, but this slows down the print and also leaves blobs or what I would describe as zits on the print. What could be causing this?
0
votes
1
answer
30
views
updated 11 months ago
How do I level the bed?
0
votes
1
answer
25
views
updated 11 months ago
What types of software do I need to make a model for the printer?
0
votes
2
answers
57
views
updated 11 months ago
What version of CURA do you typically use?