RigidBot Upgrades

  • Part No. 1064, Part No. 3015, Part No. 3062, and Part No. 3063 Includes, aluminum block, brass nozzle at .4mm, ptfe tube and heat break. See below for more information.  
    Add to cart Details
  • Part No. 4008 Extruder mounting block upgrade kit for RB1 and RBB. (stock extruders) See below for more information.  
    Add to cart Details
  • This is a positive lock heated bed works in conjunction with the upgraded cables. Direct replacement for RB2 or upgrade from RB1. It heats much faster and is more efficient. See below for more information. For RBB heated bed, click here.
    Add to cart Details
  • Part No. 2093 (qty 1) and Part No. 3014 (qty 2) This is a positive lock heated bed cable is a direct replacement for the old bed cabling. See below for more information.
    Add to cart Details
  • Part No. 3044 This is the new 4E3D Mainboard upgraded design. See below for more information.
    Add to cart Details
  • This is so great! See below for more information.
    Add to cart Details
  • Part No. 3092 This power supply is an upgrade for just about any controller board in a 3dPrinter. It was designed to run two separate 24Volt Rails at up to 550 watts total power. It has a 5volt supply, 3.3 volt supply, 12 volt and a Stand by 5v. See below for more information.
    Add to cart Details
  • Dual Extruder Upgrade for RB1 and RBB
    Part No. Machined Extruder Plates are much flatter and superior to the original stamped ones. They glide easier because of their rigid plane and will support better movement and longer bearing life. See below for more information.  
    Add to cart Details